Answers are grounded in this paper and cite their sources.
Microstructural characterization reveals dominant M6C carbide formation in 11%Cr ferritic/martensitic steel after short-term creep, highlighting rapid precipitation behavior at high temperatures.
To further increase steam temperature in ultra-supercritical power plants, 9–12%Cr ferritic/martensitic (FM) steels with target operating temperatures up to 650°C and higher are being developed. An 11% Cr F/M steel was prepared by reference to the nominal chemical composition of SAVE12 steel with an expected maximum use temperature of 650ºC. Precipitate phases in the 11%Cr FM steel after a short-term creep at 600°C/180 MPa for 1100 h were investigated by transmission electron microscopy with energy dispersive X-ray spectrometers. Precipitate phases in the crept steel were identified to be Fe-W-Cr-rich M6C carbide, Cr-rich M23C6 and M7C3 carbides, Fe-rich Laves phase, Nb-Ta-rich/Ta-Nb-rich/V-rich MX phases, as well as Fe-Cr-rich sigma phase. The identified M6C carbides with a f.c.c. crystal structure have a metallic element composition of about 41Fe, 31W, 20Cr, and 4Ta (in at.%) and an irregular block-like morphology with sizes ranging from 70 to 310 nm in diameter. The M6C and Cr-rich M7C3 carbides, as well as Fe-W-rich Laves phase are considered to be formed during the creep. The present investigation reveals that the M6C carbide is a dominant phase in the steel after the creep. The formation of the M6C carbide in the crept steel is also discussed.
No takes yet. Share an insight, caveat, or question.
Zhou et al. (2018) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: