Answers are grounded in this paper and cite their sources.
Randomized crossover trial demonstrates region-specific water-vapor accumulation in healthy men wearing film-laminated jackets, indicating that dynamic pressure analysis improves garment testing.
This exploratory study examined regional water-vapor accumulation in four commercial film-laminated hardshell jackets during a structured wear protocol. Three healthy men each completed one trial per jacket in a randomized crossover design at 20 ± 2 °C and 60 ± 4% relative humidity. Temperature and relative humidity were recorded at the underarm (P-1) and chest (P-2), with local sweat rate measured at P-2. Water-vapor partial pressure (pv) was calculated to describe the combined temperature–humidity response; pressure differences were referenced to the nominal ambient value of 1.40 kPa. Reported mean P-1 pv was lowest for B (3.76 kPa), whereas P-2 pv and local sweat rate were lowest for C (3.29 kPa and 0.33 mg cm−2 min−1). The displayed trajectories suggested greater separation during a period of 0–15 min and convergence of relative humidity after approximately 16 min. These findings support the region-specific assessment of garment microclimates and show how dynamic pv analysis can complement standard material testing when screening garment designs.
No takes yet. Share an insight, caveat, or question.
Wei et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: