Answers are grounded in this paper and cite their sources.
Experimental study demonstrates successful clinker synthesis using spent chamotte lining and microsilica, indicating potential energy savings and hazardous waste reduction.
Introduction. The cement industry is a major source of CO2 emissions, which highlights the need to implement circular economy principles, particularly the utilization of large-tonnage industrial wastes. Spent chamotte lining (SCL) from aluminum electrolyzers represents a significant environmental challenge – a Class IV hazardous refractory material containing fluorides and alkalis. The aim of this study was a comprehensive experimental assessment of the feasibility of technological integration of two types of waste – leached SCL and amorphous microsilica (MS) – into Portland cement clinker production as a replacement for traditional clayey raw material. Methods. The materials used included limestone, leached SCL, amorphous MS, and an iron-containing corrective sand. The raw mix composition was calculated and optimized using the Pearson's envelope method and solving a system of material balance equations with target values for the lime saturation factor (LSF = 0.90) and the silica ratio (SR = 2.3). Results and Discussion. Laboratory firing of pressed raw mix briquettes was conducted in a muffle furnace following a regime simulating the industrial cycle. The kinetics of decarbonation and phase formation were studied using Thermogravimetric Analysis methods with specifications. The phase composition of the clinker was determined by X-ray Diffraction Analysis, and its microstructure was examined using Scanning Electron Microscopy. The physico-mechanical properties of the obtained cement were tested according to standard methods. Conclusions. It was established that the introduction of a composite SCL+MS component (up to 14.5 % of the raw mix by mass) reduces the decarbonation temperature and the onset of alite (C3S) synthesis by 20–30 °C due to the combined effect of the high dispersity of MS and the residual mineralizing action of fluorides. The experimental clinker-based cement meets the requirements of PC 300 grade, demonstrating a 28-day compressive strength of 29.6 MPa, which is statistically indistinguishable from the control (29.8 MPa). Other critical parameters were evaluated for application which are: the equivalent alkali content (Na2Oₑq.) in SCL should not exceed 2.0–2.5 %, and its proportion in the raw mix can be 8–12 %. The results confirm the technical feasibility of utilizing hazardous waste to produce competitive cement with potential reductions in firing energy consumption.
No takes yet. Share an insight, caveat, or question.
Kuz’min et al. (2026) studied this question.