Answers are grounded in this paper and cite their sources.
Fatigue crack growth (FCG) tests were performed in two heat-treated AlMgSi aluminium alloys under constant amplitude loading, namely the 6082-T6 and 6061-T651 alloys. The parameters studied, in addition to the material, were stress ratio and thickness. Despite similar chemical composition, monotonic properties and cyclic stress–strain behaviour, the two alloys exhibited significantly different fatigue crack growth behaviour. Strong stress ratio and material dependence effects on FCG were observed, while a limited effect of thickness was found in AA6061-T651. Crack closure was able to explain the effects of material and stress ratio. The crack closure level was found to be significantly higher in the AA6061-T651, which was attributed to roughness-induced crack closure (RICC). In fact, minor changes in chemical composition produced a relatively high roughness of the fracture surface. Apparently, RICC is not affected by thickness. In AA6082-T6, plasticity-induced closure (PICC) is dominant. Analytical models of FCG and PICC were fitted to the experimental results obtained for AA6082-T6, including the effects of stress ratio and Δ K .
No takes yet. Share an insight, caveat, or question.
Borrego et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: