Answers are grounded in this paper and cite their sources.
The surface engineering of titanium with TiCxO1−x coatings through diffusion carbo-oxidising from graphite in oxygen containing media is investigated. The effect of oxygen partial pressure on phase composition of coatings during carbo-oxidising is evaluated. The interval of oxygen partial pressure allowing the carbo-oxide TiCxO1−x to form is defined as 10−2–103 Pa. The effects of process temperature and time on evolution of TiCxO1−x composition and morphology of surface layer have been investigated. It is determined that increases in temperature and process time favour an increase in carbon content in TiCxO1−x. It is revealed that at temperatures above the transformation temperature Tα⇔β, TiCxO1−x is formed not only in coating but also throughout grain boundaries of diffusion layer. The stages of carbo-oxide formation during diffusion carbo-oxidising of commercially pure titanium are explained as follows: surface saturation with oxygen; formation of TiO2 film; oxide dissolution and formation of diffusion layer; formation of non-stoichiometric TiCx and TiOx and their interaction resulting in TiCxO1−x formation. Corrosion properties of carbo-oxide coatings tested in 80%H2SO4 are compared with nitride and oxide coatings. It is revealed that carbo-oxide coating demonstrates better corrosion resistance. The tribological properties of carbo-oxide, nitride and oxide coatings tested with bronze counterbody are compared, and carbo-oxide coating demonstrates better wear resistance.
No takes yet. Share an insight, caveat, or question.
Yas’kiv et al. (2012) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: