Design and development of low‐cost optical‐fiber sensors for temperature metrology: Process monitoring of an epoxy resin system

This article reports the design and deployment of two optical‐fiber temperature sensors based on the fiber Fabry–Perot etalon. The first involved the use of an extrinsic fiber Fabry–Perot sensor, but in this instance, the coefficient of thermal expansion of the reflector and/or capillary was chosen to offer a mismatch. Hence, the cavity length could increase or decrease according to the coefficient of thermal expansion of the fiber and/or capillary. For comparison, single‐mode and multimode optical‐fiber Bragg gratings were also used as temperature sensors. The Fabry–Perot sensors operated from −50 to 410°C. The accuracy of the measurements was up to ±0.5°C with a low‐cost charged‐coupling‐device spectrometer. The sensors also worked effectively in a microwave oven and in a composite panel in an autoclave.