Answers are grounded in this paper and cite their sources.
A high-performance, wide dynamic range, fully-integrated neural interface is one key component for many advanced bidirectional neuromodulation technologies. In this paper, to complement the previously proposed frequency-shaping amplifier (FSA) and high-precision electrical microstimulator, we will present a proof-of-concept design of a neural data acquisition (DAQ) system that includes a 15-bit, low-power Delta-Sigma analog-to-digital converter (ADC) and a real-time spike processor based on one exponential component-polynomial component (EC-PC) algorithm. High-precision data conversion with low power consumption and small chip area is achieved by employing several techniques, such as opamp-sharing, multi-bit successive approximation (SAR) quantizer, two-step summation, and ultra-low distortion data weighted averaging (DWA). The on-chip EC-PC engine enables low latency, automatic detection, and extraction of spiking activities, thus supporting closed-loop control, real-time data compression and /or neural information decoding. The prototype chip was fabricated in a 0.13 μm CMOS process and verified in both bench-top and In-Vivo experiments. Bench-top measurement results indicate the designed ADC achieves a peak signal-to-noise and distortion ratio (SNDR) of 91.8 dB and a dynamic range of 93.0 dB over a 10 kHz bandwidth, where the total power consumption of the modulator is only 20 μW at 1.0 V supply, corresponding to a figure-of-merit (FOM) of 31.4fJ /conversion-step. In In-Vivo experiments, the proposed DAQ system has been demonstrated to obtain high-quality neural activities from a rat's motor cortex and also greatly reduce recovery time from system saturation due to electrical microstimulation.
No takes yet. Share an insight, caveat, or question.
Xu et al. (2020) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: