Answers are grounded in this paper and cite their sources.
Experimental study demonstrates substantial mechanical reinforcement in DLP-printable GelMA and chitosan hydrogels, highlighting a streamlined pathway for durable tissue engineering.
Photocrosslinked gelatin methacryloyl/methacrylated chitosan (GelMA/CSMA) hydrogels are attractive for biomedical applications but are limited by insufficient mechanical strength. Here, γ-methacryloxypropyltrimethoxysilane (MPTS) was prehydrolyzed and condensed to generate siloxane species retaining polymerizable methacrylate groups, which were subsequently incorporated into the GelMA/CSMA network as a reinforcing phase. The effects of MPTS precursor concentration (2–5% w/v) and prehydrolysis time (12–48 h) on the morphology, viscoelasticity, compressive behavior, cytocompatibility, and DLP printability of the resulting GCM hydrogels were systematically investigated. FTIR confirmed methoxy-group consumption while retaining C=C functionality. SEM showed that increasing MPTS precursor concentration increased the apparent abundance of granular features, whereas prolonged prehydrolysis produced larger structures. XRD indicated a predominantly amorphous MPTS-derived phase. GCM-48 h-5% achieved a storage modulus of 23.5 kPa, compressive modulus of 0.682 MPa, and maximum compressive stress of 1.081 MPa, corresponding to 7.4-, 16.9-, and 4.0-fold increases over the GelMA/CSMA control, respectively. The hydrogels exhibited favorable L929 cytocompatibility and retained DLP printability under 405 nm irradiation. These findings demonstrate that regulating MPTS precursor concentration and prehydrolysis time provides a simple route to mechanically reinforce DLP-printable GelMA/CSMA hydrogels without directly incorporating preformed silica particles.
No takes yet. Share an insight, caveat, or question.
Zhang et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: