Answers are grounded in this paper and cite their sources.
A truing technique for an electroformed diamond tool with a mesh size of #1000 that can fabricate a flat and smooth tip of diamond grains on a hemispherical wheel working surface was developed to adapt the tool to the nanometer grinding of a cemented carbide. A truing test using a polycrystalline diamond disk with a primary diamond grain size of 1μm as a truer was conducted by varying the contact load between the tool and the truer, the setting depth of cut, the grain size in the diamond slurry used as a grinding fluid and the number of traverses in no-cut grinding carried out after reaching the total wheel depth of cut. It was verified through the truing test that 51% of diamond grains on a hemispherical wheel working surface could be made flat and smooth, and that 76% of grains could be made flat by adding flattened grains with tiny cracks when the contact load, the setting depth of cut, the grain size in the diamond slurry and the number of traverses in no-cut grinding were set at 5.2N, 9μm, 0-1, and 10 times, respectively.
No takes yet. Share an insight, caveat, or question.
Gohya et al. (2010) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: