Answers are grounded in this paper and cite their sources.
Test fires of a rotating detonation engine (RDE) annular combustor operating on a methane–oxygen mixture were conducted. Compared to the original RDE combustor previously tested, it was modified in terms of changing the layout of the water cooling system, the positions of ports for sensors, and the shape of the supersonic nozzle. The stable operation process with a single detonation wave continuously rotating in the annular gap with the velocity of ~1900 m/s (rotation frequency of ~6 kHz) was obtained in the wide range of flow rates of propellant components. This is an important distinguishing feature of the present RDE combustor compared to the analogs known from the literature, which usually exhibit an increase in the number of simultaneously rotating detonation waves with an increase in the flow rates of propellant components. Compared to the original RDE combustor, the maximum duration of operation and the attained sea-level specific impulse were increased from 1 to 30 s and from 250 to 277 s, respectively. The thermal states of all heat-stressed elements of the combustor were obtained. The maximum heat fluxes are registered in the water cooling jackets of the central body and the combustor outer wall. Heat losses in the water cooling system are shown to increase with the average pressure in the combustor. The maximum value of the average heat flux over 20 MW/m2 is achieved on the combustor outer wall. The average heat flux into the combustor outer wall is approximately 20% higher than that into the central body. The average heat flux into the nozzle is several times lower than similar values for the combustor outer wall and central body. The total heat loss into the water-cooled walls of the combustor reach about 10% of the total thermal power of the combustor.
No takes yet. Share an insight, caveat, or question.
Frolov et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: