Answers are grounded in this paper and cite their sources.
This study investigates the tribo-mechanical performance of uncoated, TiAlSiN-coated, and TiSiN/TiSiVN multilayer-coated Al 2 O 3 /SiC ceramic tools during dry turning of AISI 316 L austenitic steel across three successive passes at varying cutting speeds. Key machining outputs, including cutting forces, surface roughness, cutting temperature, and tool wear (flank and crater), were analyzed with a focus on oxide formation and self-lubricating mechanisms. The TiSiN/TiSiVN-coated tool exhibited the most favorable performance, showing only ∼15 % increase in cutting force across passes, ∼9 % improvement in flank wear resistance compared to TiAlSiN, and ∼ 17 % lower wear progression relative to the uncoated tool at 350 m/min. Surface roughness and cutting temperature trends further confirmed the coating's superiority, attributed to the formation of V₂O₅ tribo-oxides, which reduce friction and thermal degradation. EDS and SEM analyses validated the wear protection mechanisms, highlighting the adaptive role of vanadium-based layers in mitigating adhesion and thermal fatigue. The results establish TiSiN/TiSiVN as a promising candidate for high-speed dry machining due to its superior mechanical-chemical synergy and wear resistance. • Cutting Forces progressively increased across passes for all tools; however, TiSiN/TiSiVN exhibited the lowest rise (∼15%) • TiSiN/TiSiVN displayed the smallest percentage increase (∼12%) in coefficient of friction owing to the lubricating effect of V₂O₅ films. • TiSiN/TiSiVN coated tool accounted to ∼30% lower Ra values compared to the uncoated tool • TiSiN/TiSiVN maintained thermal control with ∼20–25% lower temperature rise due to oxide barrier layers.
No takes yet. Share an insight, caveat, or question.
Kumar et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: