Answers are grounded in this paper and cite their sources.
The influence of a preceding laser ablation surface treatment on cold roll bonding (CRB) efficiency under extreme high vacuum-adequate (XHV-adequate) conditions were examined. Experimental investigations were conducted in a controlled glovebox environment. The impact of varying laser parameters on the critical reduction required for bonding copper and aluminium sheets was analysed. The results demonstrate a significant reduction in critical deformation necessary for bond formation. Surfaces treated by laser ablation achieve bonding at plastic deformations as low as 0.5%. In comparison, brushed surfaces require a plastic strain of 19% in similar XHV-adequate conditions. Using confocal laser scanning microscopy, a correlation between laser parameters and resulting surface characteristics was established, revealing material-specific surface alterations. Scanning electron microscopy analysis of the bonded interfaces further shows enhanced interfacial deformation in laser-treated specimens, which is characterised by increased waviness and pronounced protrusions. The investigations demonstrate a synergistic effect between laser-induced surface modifications and oxide-free conditions in an XHV-adequate atmosphere, which leads to a significant optimisation of CRB efficiency.
No takes yet. Share an insight, caveat, or question.
Barienti et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: