Answers are grounded in this paper and cite their sources.
This paper presents experimental measurements of adiabatic effectiveness for three transpiration cooling porosities (ϕ= 0.3, 0.4, and 0.5) constructed from gyroid lattice structures. To the authors’ knowledge, this is the first use of a Triply Periodic Minimal Surface (TPMS) function to produce transpiration test coupons of varying porosity. Polymer gyroid lattice structures were successfully printed using Stereolithography (SLA) down to ϕ= 0.3 for a print resolution of 25 microns and unit cell size of 2 mm. Cooling performance was measured in a small-scale wind tunnel. High-resolution Infrared Thermography was used to determine wall temperatures downstream of the porous section. When tested at both common blowing ratios (M = 0.029, 0.048, and 0.062) and common injection ratios (F = 0.010, 0.017, and 0.022) the cooling performance was found to be dependent on porosity for constant M but not for constant F. Having determined F as the more important parameter for comparison, results are presented alongside transpiration and effusion data from literature.
No takes yet. Share an insight, caveat, or question.
Brimacombe et al. (2023) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: