Answers are grounded in this paper and cite their sources.
Purpose: The study aimed to assess and compare the fracture toughness of resin-bonded fixed dental prosthesis (RBFDP) of different ceramic materials and connector parameters. Methods: Twenty extracted human incisal teeth were utilized as abutments for the RBFDP. Zirconia (Zir) and lithium disilicate (LD) were manufactured in the form of anterior cantilever RBFDPs (n = 10 per group). Each material was tested using two connector designs, with the following dimensions for height (h), base (b), and width (w): 5 (h) × 4 (b) × 1 (w) mm (n = 5), and 4 (h) × 2 (b) × 1 (w) mm (n = 5). Prostheses were computer-aided design and computer-aided manufacturing (CAD/CAM) fabricated from Zir (IPS e.max ZIRCAD prime) and LD (IPS e.max CAD). Surface pretreatment of the prosthesis was completed prior to cementation with a dual-cured resin cement (Rely-X Ultimate). The combined teeth and prostheses were subjected to thermocycling before load-to-fracture testing at 45-degrees in the center of the pontic using a universal testing machine (Shimadzu Universal Testing Machine). The types of fracture failures were observed and classified as either favorable (non-catastrophic/repairable) or unfavorable (catastrophic/non-repairable) when viewed under an electron microscope. Results: The highest fracture toughness was observed in 5 (h) × 4 (b) × 1 (w) mm for Zir, reaching 269 ± 27 N, and LD, reaching 180 ± 83 N. The lowest values were found in 4 (h) × 2 (b) × 1 (w) mm for Zir at 237 ± 52 N and LD at 116 ± 25 N. Two-way ANOVA showed the fracture strength for dimension 5 (h) × 4 (b) × 1 (w) mm was significantly higher compared to dimension 4 (h) × 2 (b) × 1 (w) mm after adjusting for the type of material (p = 0.02). One Zir sample, measuring 5 (h) × 4 (b) × 1 (w) mm, exhibited tooth fracture under applied load. Meanwhile, two LD samples of the same dimensions became decemented under load. Conclusions: RBFDPs made from Zir exhibited a pattern of higher load-to-fracture values compared to LD for all dimensions; however, this was not statistically significant. The connector parameter has a more significant influence compared to the material used to fabricate an RBFDP in the anterior region.
No takes yet. Share an insight, caveat, or question.
Ghani et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: