Answers are grounded in this paper and cite their sources.
Phosphors for fluorescent lamp coatings are commonly composed of particles predominantly from 2 to 5 μ in diameter, and weighing about 1.5 to 2 g./l,000 cm.2 of surface covered. For maximum luminous efficiency an optimum coating thickness exists, below which the exciting radiation is not fully utilized, and above which absorption of the generated light is excessive. Optical measurements, such as those of transmittance or reflectance, permit the most convenient and accurate control to maintain this optimum thickness in lamp manufacture. The absorptance of commercial coatings commonly runs 7% to 10%. The internal brightness of fluorescing coatings in operating fluorescent lamps is usually 1.6 to 2.0 times the externally viewed brightness, which is also the approximate ratio of reflectance to transmittance. An extended length of coating, about 6 times the diameter of the coated bulb, is required before brightness at the center of the coated section reaches maximum, produced by multiple internal reflections. Optimum‐thickness coatings utilize 98% to 99% of the exciting ultraviolet radiation which strikes them. Calculations based on fluorescent coating efficiency in F lamps indicate quantum efficiencies of about 90% for the zinc beryllium silicate and magnesium tungstate phosphors used in white and daylight colors. No appreciable saturation or fatigue effects have been attained on fluorescent coatings under attainable test conditions of ultraviolet excitation in or outside of the lamps. Both theory and experiment have demonstrated little or no advantage for proposals to improve lamp efficiency or light output which are based on assumptions of saturation or on attempts to utilize the high internal brightness.
No takes yet. Share an insight, caveat, or question.
R. N. Thayer (1945) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: