Answers are grounded in this paper and cite their sources.
The operating temperature of photovoltaic (PV) modules is a primary determinant of their electrical conversion efficiency, with performance typically deteriorating as cell temperature increases beyond the manufacturer-rated condition. This study investigates Nano-Enhanced Phase Change Materials (NePCM) as a passive thermal management strategy to mitigate temperature-induced efficiency loss, using palm wax as the base phase change material (PCM) instead of the paraffin-based formulations that dominate the existing literature. Palmwax-based NePCM composites were fabricated by dispersing aluminum oxide (Al2O3), silicon dioxide (SiO2), and zinc oxide (ZnO) nanoparticles at a mass fraction of 2 wt% via a two-step method, enabling a controlled, side-by-side comparison of nanoparticle type under identical fabrication and testing conditions. The chemical stability, dispersion morphology, and thermal degradation behavior of each composite were characterized using Fourier-transform infrared spectroscopy (FTIR), scanning electron microscopy with energy-dispersive X-ray spectroscopy (SEM-EDX), and thermogravimetric analysis (DTG). Electrical and thermal performance were subsequently evaluated under outdoor field conditions on a rooftop installation in Surakarta, Indonesia, between September and October 2025, with solar irradiance ranging from 400 to 1000 W/m² and a measurement uncertainty in electrical efficiency of below 2%. FTIR results confirmed that the characteristic functional groups of palm wax remained intact following nanoparticle incorporation. At the same time, SEM-EDX revealed uniform nanoparticle distribution in the Al2O3 and SiO2 composites, contrasted by partial agglomeration in the ZnO composite. Despite this morphological difference, the Palm-ZnO configuration exhibited the most favorable thermal and electrical performance among all tested composites, reducing panel surface temperature by up to 3.42 °C, increasing peak power output to 41.18 W, and improving average electrical efficiency to 13.06%, a 13.24% gain relative to the uncooled baseline. One-way ANOVA confirmed that these differences among nanoparticle types were statistically significant for both temperature reduction (F = 132.57, p < 0.001) and power output (F = 124.38, p < 0.001). These findings indicate that nanoparticle type, rather than loading concentration alone, is the dominant factor governing NePCM cooling performance. That palm wax constitutes a technically viable, renewable base material for scalable passive PV cooling applications.
No takes yet. Share an insight, caveat, or question.
Choifin et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: