This is the authors' abstract. We don't add key points for this paper.
Plant-derived materials frequently exhibit poor flowability and compactibility, complicating their conversion into solid dosage forms. This preliminary study investigated whether chemically complex spray-dried extracts of Eugenia uniflora and Punica granatum could be processed using semi-solid extrusion (SSE) 3D printing and how extract identity and manufacturing route influence the resulting product attributes. For this purpose, printed units were compared with nominally composition-matched tablets produced by wet granulation followed by compression to characterize the mechanical, disintegration, and marker-dissolution behavior associated with each process. Following paste screening, a 2 3 factorial design identified sodium starch glycolate, filled top/bottom layers, and drying at 24 °C as the combination providing the most favorable balance between mechanical strength and disintegration for both extracts. Under the selected geometries, printed units weighed 701–751 mg, compared with 501–502 mg for compressed tablets with conventional punches design, while all formulations showed friability below 1%. Printed units required higher breaking forces than compressed tablets for P. granatum (44.2 ± 2.95 vs 31.3 ± 4.27 N) and E. uniflora (57.4 ± 4.05 vs 30.8 ± 2.80 N), accompanied by longer disintegration and slower initial marker dissolution. Printed P. granatum units approached complete marker dissolution within 30 min, whereas printed E. uniflora units reached approximately 75–80%. These findings provide preliminary evidence that SSE can process complex plant extracts into mechanically resistant solid forms. However, extract-dependent differences demonstrate that fully exploiting the design and dose flexibility of SSE requires formulation and process optimization according to the composition of the incorporated botanical matrix and the intended product performance.
Answers are grounded in this paper and cite their sources.
No takes yet. Share an insight, caveat, or question.
Bitú et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: