Answers are grounded in this paper and cite their sources.
Grain boundaries in polycrystalline Bi 2 Te 3 - and Sb 2 Te 3 -based thermoelectric materials may strongly modify charge transport through electrostatic band bending and space-charge-layer formation. In this work, surface-potential-controlled intergranular conductance is analyzed theoretically within the framework of classical semiconductor electrostatics and the grain-boundary barrier model. Calculations were performed at T = 300 K for p-type Bi 2 Te 3 and Sb 2 Te 3 using the dimensionless carrier-imbalance parameters ξ = 300 , 1000, and 3000 over the surface-potential interval − 15 ≤ Y s ≤ 25 . Both the absolute conductance variation | Δ G | and the signed conductance variation Δ G were evaluated. For negative surface potentials, Δ G > 0 because of hole accumulation near the grain boundary. Moderate positive surface potentials produce Δ G < 0 , corresponding to majority-carrier depletion. At larger positive Y s , the increasing electron contribution drives Δ G back toward positive values, producing a second zero crossing of the integrated conductance variation. Increasing ξ enhances the accumulation-side response, deepens the depletion minimum, and shifts this second zero crossing from Y s ≈ 13.7 for ξ = 300 to Y s ≈ 18.7 for ξ = 3000 . The dimensionless electrostatic part of the response has the same qualitative form for both materials under identical ξ and mobility-ratio conditions, whereas the dimensional amplitudes differ C = q μ p L i n i 2 through the material-dependent prefactor. The calculated values are 1.015 × 1 0 − 5 S for Bi 2 Te 3 and 5.297 × 1 0 − 6 S for Sb 2 Te 3 . Consequently, for the representative parameter sets considered here, the Bi 2 Te 3 conductance response is approximately 1.92 times larger than that of Sb 2 Te 3 . The results clarify the separate roles of surface potential, carrier imbalance, and material parameters in grain-boundary-controlled transport. The model is intended to describe qualitative electrostatic trends and does not constitute a direct calculation of the Seebeck coefficient, thermal conductivity, power factor, or thermoelectric figure of merit.
No takes yet. Share an insight, caveat, or question.
Onarkulov et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: