Answers are grounded in this paper and cite their sources.
: Wire arc additive manufacturing (WAAM) enables efficient fabrication of large Mg–Gd–Y–Zn–Zr alloy components, but the as-deposited microstructure usually shows pronounced heterogeneity that affects subsequent hot deformation and aging. In this work, a CMT-WAAM-fabricated VW93A alloy was subjected to two routes: direct hot deformation plus aging, and solution pretreatment followed by the same hot deformation and aging schedule. Solution pretreatment at 520 °C for 24 h reduced the retained grain-boundary eutectic, alleviated Gd, Y, and Zn segregation, and lowered the average kernel average misorientation from 0.83 to 0.40. After hot deformation, the solution-pretreated alloy exhibited a higher dynamic recrystallization fraction and a more homogeneous equiaxed grain structure. After aging, the directly processed route showed a precipitate-free zone (PFZ) of ∼50–70 nm near some grain boundaries, whereas no obvious PFZ was observed in the examined regions of the solution-pretreated route. The latter also showed finer intragranular β′ precipitates and a higher precipitate area fraction. As a result, the solution-pretreated, hot-deformed, and aged alloy achieved the best tensile properties, with an ultimate tensile strength of 429 MPa, a tensile yield strength of 347 MPa, and an elongation of 7.5%. These results indicate that solution pretreatment is effective for regulating the initial WAAM microstructure and improving the subsequent hot-deformation and aging response.
No takes yet. Share an insight, caveat, or question.
Lu et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: