Answers are grounded in this paper and cite their sources.
Experimental study demonstrates polymer-dependent microchannel fabrication and wettability shifts during visible diode laser processing, highlighting tailored surface engineering for 3D-printed...
Additive manufacturing enables rapid fabrication of polymer components, but the direct production of well-defined microchannels remains challenging. Laser processing offers an attractive approach for introducing microscale features and modifying polymer surface properties. This study investigates visible diode laser processing of four additively manufactured polymers: acrylonitrile butadiene styrene (ABS), polyethylene terephthalate glycol (PETG), Anycubic Standard resin, and Industrial Rigid resin. Laser-processing conditions were screened and selected for each material, and surface modifications were evaluated using attenuated total reflectance Fourier transform infrared (ATR-FTIR) spectroscopy, contact angle measurements, and surface free energy calculations. ABS and PETG enabled successful microchannel formation, whereas continuous microchannels could not be obtained in the photopolymer resins under the investigated conditions. ATR-FTIR analysis revealed material-dependent surface modifications while largely preserving the characteristic polymer fingerprints. Laser treatment increased the water contact angle of ABS from 88.9° to 122.3° and PETG from 73.5° to 92.2°. In contrast, it decreased from 85.4° to 59.0° for Anycubic Standard resin and from 103.7° to 81.6° for Industrial Rigid resin. These contrasting responses demonstrate that diode laser processing can induce microstructuring, surface modification, or both, depending on the polymer substrate.
No takes yet. Share an insight, caveat, or question.
Forjan et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: