Answers are grounded in this paper and cite their sources.
Membranes used in fuel cells and electrolysers are often assumed to have homogeneous water transport properties. However, some studies report an interfacial resistance, , potentially arising from structural differences in the first micrometers of the membrane compared to its bulk/center. In this work, of a PiperION membrane was estimated by using several thicknesses of the same material in a permeation setup, under both vapor–vapor and liquid-vapor configurations. Measurements were conducted in-situ to replicate actual operating conditions, thus water vapor transport in the gas phase was considered. GDLs with MPLs and without were used, enabling measurement of the Knudsen water transport resistance in the MPL. The bulk diffusion coefficient related to purely diffusive water transport through the membrane was also estimated. The impact of the temperature and the relative humidity on the water transport properties was investigated. An increase of temperature had a beneficial impact by lowering . Conversely, increased while increasing the relative humidity. The highest contribution of (35%) was found when using thin membranes (20 μm thick). Additionally, permeation measurements were performed in liquid-vapor configuration with different types of liquid: water and a KOH solution. Higher water flux were observed in liquid-vapor measurements than in vapor-vapor measurements. Results showed better water transport properties in form than in form. In the form, was higher when the membrane was in contact with water compared to with KOH solution. Finally, adding a catalyst layer on the membrane increased the water transport resistance.
No takes yet. Share an insight, caveat, or question.
Leduc et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: