This is the authors' abstract. We don't add key points for this paper.
OBJECTIVE: to evaluated the influence of two types of low-fusing porcelain glaze application on the surface of a zirconia ceramics stabilized by yttrium (Y-TZP).METHODS: Y-TZP specimens were divided into five groups (n=5) according the surface treatments: control (CO), no treatment was performed; application of a thin low-fusing porcelain glass layer by the powder/liquid technique (GPL); GPL followed by 10% hydrofluoric acid (HF) etching (GPL-HF); glaze spray application (GS); GS followed by 10% HF etching (GS-HF). Roughness measurements contact angle, x-ray diffraction, energy-dispersive spectroscopy (EDS) and scanning electron microscope (SEM) analysis were performed.RESULTS: ANOVA and Tukey tests revealed that GPL had significantly lower contact angle values than the other groups (GPL:50.31º; GPL-HF: 72.73º; GS-HF: 81.73º; CO: 96.48º; GS:101.30º; p=0.001). GPL-HF presented a significant higher roughness (Ra/Rq: 2658.0/3367.0 ηm; p=0.001) than the other groups (GPL: 872.1/1162.0 ηm; GS-HF: 383.0/603.6 ηm; GS: 303.4/391.3 ηm; CO:263.4/339.1 ηm). The X-ray diffraction analysis just tetragonal phase in all groups. EDS and SEM analysis show a highest amount of silica on GPL and GPL-HF surface.CONCLUSION: the application of the low-fusing porcelain glaze by the powder/liquid technique followed by the HF etching promoted a better surface to micromechanical and chemical adhesion.
Answers are grounded in this paper and cite their sources.
No takes yet. Share an insight, caveat, or question.
Miranda et al. (2018) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: