Answers are grounded in this paper and cite their sources.
Translation of tensile properties from high-performance fibers to end-use fabrics is sensitive to weaving-induced filament defects and environmental exposure. In this effort, isolated and combined effects of hygrothermal exposure and curvature-induced kink bands on tensile strength of Vectran™ HT (polyarylate liquid crystal polyester fiber) and Kevlar® KM2 are studied. Hygrothermal conditioning was conducted at temperatures ranging from 40℃ to 100℃ in water for 30 days. Curvature-induced defects were created by wrapping tows around stainless steel rods of different diameters (0.25 mm to 5 mm) to create kink bands. Combined effects were evaluated by conditioning tows with kink bands at 100℃ for 30 days. All conditioned samples were dried and tested at room temperature. Hygrothermal aging showed that tensile properties for Vectran fibers were not appreciably affected below 100℃ (∼12% reduction), while KM2 fibers dropped continuously with increasing temperatures (∼48% at 100℃). The influence of curvature on kink band density was established for each fiber type. The isolated effect of kink band density on residual strength was approximately 15% for both Vectran 1670/600 and KM2-600. Combined effects of curvature-induced kink bands followed by hygrothermal exposure showed significant reductions in tenacity up to ∼96% for KM2 and 60% for Vectran HT1670/600. Inspection of the microstructure within the kink bands reveals extensive micro-cracking and fibril failure due to accelerated moisture ingress.
No takes yet. Share an insight, caveat, or question.
Obaid et al. (2015) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: