Answers are grounded in this paper and cite their sources.
In laser ablation dicing, a wafer is separated into individual dies by focusing a short-pulse laser beam onto the wafer surface. In the dicing process, an in situ technique for monitoring the processing state is highly desirable to reduce defective products and shorten the processing time. In this paper, we propose a method for detecting processing depth and wafer penetration by measuring the recoil force induced by laser ablation. Fundamental experiments relevant to laser dicing were conducted using the laser drilling of silicon samples. The ablation-induced recoil force was measured with a load cell during the irradiation of a silicon wafer using a 1064-nm laser with a pulse duration of 25 ns. Single-pulse irradiation of a fresh surface produced a recoil force waveform exhibiting damped oscillations. The peak amplitude of the recoil force increased almost linearly with pulse energy and decreased monotonically with increasing beam area. Under multi-pulse irradiation, the recoil force decreased monotonically with increasing processing depth, and a distinct change in the recoil force behavior was observed at the pulse number corresponding to wafer penetration. These results demonstrate that both the processing depth and wafer penetration can be detected in situ through recoil force measurements, indicating the potential of the proposed method for monitoring laser dicing processes.
No takes yet. Share an insight, caveat, or question.
Satô et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: