Answers are grounded in this paper and cite their sources.
Additive manufacturing (AM) of silicon carbide (SiC) enables the fabrication of complex geometries that are difficult or impossible to produce using conventional processing routes. However, the development of processable SiC feedstocks for powder bed fusion (PBF) remains a significant challenge because high packing density, good powder flowability and sufficient binder distribution must be simultaneously achieved. In this study, twelve Washington Mills Carborex SiC powders were characterised and a three-parameter packing model employed to predict the relative packing densities of the PA6-coated SiC bimodal mixtures for polymer-assisted PBF. Guided by model predictions and experimental validation, the SiC powder feedstock, comprising 70 wt% coarse SiC and 30 wt% PA6-coated fine SiC particles, was taken forward for processing by PBF. This formulation provided a favourable balance between packing efficiency, powder flowability and binder connectivity. Using this engineered feedstock, SiC green parts were successfully fabricated by PBF, achieving a green density of 1.16 g cm −3 , approximately 20% higher than that obtained using a unimodal coated feedstock (0.96 g cm −3 ). The results show that effective feedstock design for ceramic PBF depends on balancing particle packing, powder flowability, and binder distribution. They also demonstrate that tailored PSD engineering is a robust route to improving green-part formation and enabling the development of processable SiC feedstocks for ceramic AM.
No takes yet. Share an insight, caveat, or question.
Liu et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: