Answers are grounded in this paper and cite their sources.
This study aims to explore fabrication and mechanical characterization of a 3-layer surface composite fabricated using underwater friction stir additive manufacturing (UFSAM) of Al2014-ZrO 2 /TiC material. The process was performed with different rotational speeds (1000, 1100 and 1200 rpm) and transverse speeds (40, 50 and 60 mm/min). The fabricated specimens were tested for the tensile strength and Vickers hardness, for the tensile strength and Vickers hardness, which were maximum at 446 ± 4.6 MPa and 156 ± 3.5 HV, respectively, at the optimum values of 1100 rpm rotational speed and 50 mm/min. The following nanomechanical properties were obtained hardness (138 ± 4.5 to 156 ± 3.5HV), elastic modulus (72.4 to 80.6 GPa), elastic recovery (23.8 to 30.7%), H/E ratio (0.0250 to 0.0269), H 3 /E 2 ratio (0.00113 to 0.00166), maximum penetration depth (hmax = 288 nm), and residual/final depth (hf-186 nm). The effect of the strain rate on the indentation response was also investigated ranging from 0.005 to 1.000 s -1 . An indentation size effect (ISE) was also noticed at all strain rates. The underwater processing environment further promoted rapid heat dissipation, which restricted excessive grain growth and contributed to microstructural refinement. A series of jump strain-rate tests showed a typical sawtooth-type hardness response, with small, instantaneous jumps in hardness with each increase in strain rate, suggesting strain-rate sensitivity in the deformation mechanism. Microstructural assessment using the SEM micrographs revealed a uniform array of nanoindentation impressions and fair distribution of ZrO 2 /TiC reinforcement particles in the Al 2014 matrix.
No takes yet. Share an insight, caveat, or question.
Maurya et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: