Answers are grounded in this paper and cite their sources.
Active biodegradable packaging is commonly developed by optimising the coating formulation, while substrate processing is regarded as a secondary manufacturing consideration. This study demonstrates that the moulding route of poly(L-lactide-co-ethylene adipate) (PLA–pLEA) films strongly influences the performance of pullulan coatings containing yerba mate extract. Films produced by injection moulding (IM) and compression moulding (CM) were air-plasma-treated and dip-coated under identical conditions. Before treatment, IM and CM films exhibited crystallinities of 10.6% and 40.0%, respectively, during the first DSC heating scan, but similar values after their thermal histories were erased (28.1% and 30.2%). XPS also revealed differences in surface composition and plasma response, with nitrogen incorporation (0.9 at.%) and the largest increase in polar surface free energy occurring only on the IM surface. These differences affected coating formation: pullulan and extract-loaded layers were approximately 110 and 200 µm thick on IM substrates, compared with 70 and 130 µm on CM substrates. SEM showed largely continuous coatings with isolated cracks on IM films, whereas CM films developed connected crack networks with exposed substrate. Both extract-loaded coatings scavenged more than 95% of ABTS and DPPH radicals within 15 min. However, only IM_pul_yerba exhibited antibacterial activity, producing inhibition zones of approximately 7 mm against Bacillus subtilis and 0.5 - 3 mm against Escherichia coli. Overall migration into 95% ethanol increased from 2 to 6 mg/dm² after coating, remaining below the 10 mg/dm² limit established by Regulation (EU) No 10/2011. The IM system released approximately twice as much chlorogenic acid (0.0336 versus 0.0181 mg/mL) and rutin (0.0200 versus 0.0119 mg/mL), while the CM system released a larger unassigned residue. Thus, an identical active formulation can exhibit different antibacterial, UV-barrier, and migration behaviour as a function of the substrate moulding route, establishing processing history as a key design variable in active biodegradable packaging.
No takes yet. Share an insight, caveat, or question.
John et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: