Answers are grounded in this paper and cite their sources.
Wire arc additive manufacturing (WAAM) of magnesium alloy has attracted significant attention due to its potential for producing large-scale, lightweight structural components. However, different heat accumulation can cause geometric instability during multilayer fabrication. In this work, the effect of three deposition strategies (reciprocating deposition without cooling, unidirectional deposition with a 60 s cooling, and reciprocating deposition with a 60 s cooling) on the formability, microstructure, and mechanical properties of thin-walled AZ31 magnesium alloy fabricated via a gas metal arc welding-based wire arc additive manufacturing (WAAM-GMAW) technology is investigated. Without cooling, severe heat accumulation causes deformation and collapse. Unidirectional deposition with cooling improves layer uniformity but generates a progressive height difference between the wall ends. In contrast, reciprocating deposition with a 60 s inter-layer cooling interval effectively reduces end-height discrepancies and enables stable fabrication of a 45-layer thin wall. The resultant component exhibits an equiaxed α-Mg matrix with fine Mg 17 Al 12 secondary phases. The grain size exhibits a gradually coarsening gradient distribution from the bottom (12.3±0.8 μm) toward the top (17.6±1.3 μm). The component shows significant isotropy in tensile and compressive properties. The tensile strength surpasses 245 MPa with an elongation above 14.5%, which meets the standards for wrought AZ31B alloy sheets while offering superior compressive strength (∼434 MPa). These results demonstrate that coordinated control of deposition path and inter-layer cooling time improves the formability and structure–property consistency of WAAM-GMAW AZ31.
No takes yet. Share an insight, caveat, or question.
Fu et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: