This is the authors' abstract. We don't add key points for this paper.
While previous work has shown that Al 2 O 3 additions (0–15 wt.%, micro- and nano-sized) progressively improve the wear resistance of AlCoCrFeNi high-entropy alloy (HEA) composites fabricated by mechanical alloying (MA) and spark plasma sintering (SPS), their compressive response remains unexplored. This study addresses this gap by evaluating the effect of reinforcement size (micro- vs. nano-Al 2 O 3 ) and content (5, 10, and 15 wt.%) on the compressive behavior and fracture characteristics of AlCoCrFeNi-Al 2 O 3 composites fabricated by MA-SPS at 1000 °C. Compressive performance of the micro-Al 2 O 3 composites improved progressively with content, peaking at 15 wt.% with a yield strength of 2432.67 MPa, ultimate strength of 2574.89 MPa, and elastic modulus of 182.24 GPa. In contrast, nano-Al 2 O 3 composites showed progressively lower strength despite a slight modulus increase, with the 15 wt.% sample reaching only 1783.40 MPa yield strength, 1865.36 MPa ultimate strength, and 121.88 GPa modulus. Fractographic analysis showed ductile microvoid coalescence and localized shear in the base alloy and micro-Al 2 O 3 composites, whereas nano-Al 2 O 3 composites exhibited particle agglomeration and early crack propagation, reducing plastic deformation. Reinforcement size thus plays a more critical role than content in determining the composites' compressive performance. Uniformly dispersed micro-Al 2 O 3 particles enhance load transfer and deformation resistance, whereas agglomerated nano-particles promote strain localization and premature failure. These findings offer practical guidelines for designing high-strength, particle-reinforced HEA composites.
Answers are grounded in this paper and cite their sources.
No takes yet. Share an insight, caveat, or question.
Ghanbariha et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: