Answers are grounded in this paper and cite their sources.
A microwave assisted chemical vapour infiltration (MW-CVI) technique has been used to manufacture tubular SiC f /SiC composites. Rapid heating and a non-uniform temperature distribution along the tube was observed, leading to both axial and radial non-uniform SiC deposition. Deposition of SiC started from the hottest location during microwave heating, which was the bottom half of the tube. Starting from a preform with a density of 0.88 g/cm 3 , a tubular SiC f /SiC composite with a density of 1.99 g/cm 3 was achieved after only ∼21 h of the MW-CVI process and total processing time was estimated to be approximately 50 h, which is significantly faster than conventional standard CVI that can take up to 1000 h. The deposited SiC matrix showed a highly crystallised structure and a lower content of carbon than in the fibres. The modelling confirmed that controlled densification from inner to outer surface was achieved and a link between the properties and infiltration dynamics has been demonstrated.
No takes yet. Share an insight, caveat, or question.
Li et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: