Answers are grounded in this paper and cite their sources.
Sulfur compounds in diesel fuel pose environmental and industrial challenges, necessitating effective removal methods. In this study, a bimetallic Cu-Fe/TiO 2 nano-photocatalyst was developed for the photooxidation of dibenzothiophene (DBT) in model diesel oil. Response Surface Methodology (RSM) with Central Composite Design (CCD) was employed to optimize both the preparation parameters of Cu-Fe/TiO 2 and the photooxidation conditions for DBT in model diesel oil. The photocatalyst was synthesized via a wet-impregnation method. Four factors were optimized during catalyst preparation: calcination temperature (400–600 °C), calcination duration (1–3 h), Cu:Fe mass composition (1–0.82), and total metal loading (1.0–3.0 wt%). For the photooxidation process, two parameters were evaluated: the H 2 O 2 :S DBT molar ratio (2−6) and catalyst dosage (0.5–1.5 g L −1 ). Both RSM models were statistically significant (p < 0.0001). ANOVA results showed lack-of-fit values of 47.67 and 70.64, with R 2 values of 0.9892 and 0.9695 for catalyst preparation and photooxidation, respectively, confirming strong model reliability. Complete DBT conversion was achieved when the catalyst was prepared using a Cu:Fe mass composition of 0.91 (10:1), a metal loading of 2.0 wt%, a calcination temperature of 502 °C, and a calcination duration of 1.02 h. For the photooxidation reaction, full DBT conversion occurred at a H 2 O 2 : S DBT molar ratio of 4 and a catalyst dosage of 1.0 g L −1 . These findings demonstrate the high efficiency of Cu-Fe/TiO 2 and highlight its potential as a promising photocatalyst for sulfur removal applications. Fig. 1. The response surface and contour plots of DBT convesion (%) as a function of (a) Cu:Fe mass composition with Cu-Fe metal loading, (b) Cu:Fe mass composition with calcination temperature, (c) Cu:Fe mass composition with calcination duration, (d) Cu-Fe metal loading with calcination temperature, (e) Cu-Fe metal loading with calcination duration and (f) calcination temperature with calcination duration • 100 % DBT removal from n -dodecane using Cu-Fe/TiO 2 . • Optimal catalyst: Cu:Fe 0.91 (10:1), loading 2.0 wt%, calcined at 502 °C, 1.02 h. • Best photooxidation: H 2 O 2 :S DBT 4, catalyst dosage 1.0 g L −1 . • RSM models show high reliability • Cu-Fe/TiO 2 offers highly efficient, practical solution for sulfur removal.
No takes yet. Share an insight, caveat, or question.
Zaid et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: