Answers are grounded in this paper and cite their sources.
Increasing the hydrophilicity of polylactide (PLA) based scaffolds is a key challenge in tissue engineering, often addressed by the incorporation of hydrophilic additives. Following this trend, in this study, PLA was admixed with polymaleate- l -cysteine (Cys)/N-acetyl- l -cysteine (NAC) conjugates at equilibrium and electrospun. The research hypothesis stated that the conjugates would increase PLA hydrophilicity due to the presence of amino acid amine and carboxylic groups. To fulfil the assumption, the obtained scaffolds were tested for water contact angle ( WCA ) and water sorption ( WS ). The remaining physico-mechanical properties, including tensile strength ( σ ) and modulus ( E ), glass transition temperature ( Tg ), melting temperature ( Tm ), decomposition temperature( Td ), and degradation rate, were determined to assess whether the modification had a negative impact on the scaffolds' physico-mechanical performance. The modified scaffolds had i) a hydrophilic surface ( WCA below 40°), ii) WS up to 5-fold higher than the PLA scaffold, iii) similar to the PLA scaffold Tg , Tm , and Td , iv) lower than the PLA scaffold σ and modulus E, and v) higher than the PLA scaffold degradation rate. A more detailed analysis of the obtained values indicates that the PLA scaffold modified with the poly (propylene maleate)-NAC conjugate showed the highest potential for application. It showed a WCA of 20°, WS of 288%, Tg of 59 °C, Tm of 152 °C, Td above 230 °C, σ of 1.9 MPa, E of 72.2 MPa, and the slowest degradation rate (30% weight loss after 90 days).
No takes yet. Share an insight, caveat, or question.
Chrószcz-Porębska et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: