Answers are grounded in this paper and cite their sources.
The article dwells on a development of new non-invasive measurement methods of optical parameters of biological tissues, which are responsible for the scattering and absorption of monochromatic radiation. It is known from the theory of radiation transfer [1] that for strongly scattering media, to which many biological tissues pertain, such parameters are parameters of diffusion approximation, as well as a scattering coefficient and an anisotropy parameter. Based on statistical modeling the paper examines a spread of non-directional radiation from a Lambert light beam with the natural polarization that illuminates a surface of the biological tissue. Statistical modeling is based on the Monte Carlo method [2]. Thus, to have the correct energy coefficient values of Fresnel reflection and transmission in simulation of such radiation by Monte Carlo method the author uses his finding that is a function of the statistical representation for the incidence of model photons [3]. The paper describes in detail a principle of fixing the power transmitted by the non-directional radiation into biological tissue [3], and the equations of a power balance in this case. Further, the paper describes the diffusion approximation of a radiation transfer theory, often used in simulation of radiation propagation in strongly scattering media and shows its application in case of fixing the power transmitted into the tissue. Thus, to represent an uneven power distribution is used an approximating expression in conditions of fixing a total input power. The paper reveals behavior peculiarities of solution on the surface of the biological tissue inside and outside of the incident beam. It is shown that the solution in the region outside of the incident beam (especially far away from it), essentially, depends neither on the particular power distribution across the surface, being a part of the tissue, nor on the refractive index of the biological tissue. It is determined only by the total input power and by parameters of radiation propagation and absorption inside biological tissues. In addition, a special choice of the boundary conditions allowed us to obtain the model solution for which the value of the biological tissue output power in the region that is outside of the beam possessed this property as well. There is a proposal to use these features of the model solutions for non-invasive defining the diffusion approximation parameters by the method of calculation similarly to that used for non-invasive measurement of parameters of stationary heat exchange in living tissues [15]. Thus, to provide unambiguous recovery of two unknown parameters of diffusion approximation in accordance with the found model solution are used measurement results of two values that are subsurface illumination and total output power. Thus, the method does not require the spatial resolution of the diffusely reflected power, which can be advantageous for measurements on real living tissues as compared with methods using "point" nature of the measurement, for example using fiber optic sensors. In addition to the effect of fixing the power transferred into the tissue, the use of nondirectional radiation enables us to measure the value of the sub-surface illumination, as well as the value of the total coefficient of reflection from biological tissue. Being known total reflection coefficient with known (or having been already measured) parameters of diffusion approximation allows us to determine additionally two more parameters characterizing the scattering medium, i.e. a scattering coefficient and an anisotropy parameter. The obtained values of the main parameters (absorption coefficient, scattering coefficient, and anisotropy parameter) provide the problem solution to find distribution of radiation of emerging heat sources for a given biological tissue already under any conditions using, for example, the Monte Carlo method. Thus, the conducted study has shown that the non-invasive measurement of parameters of radiation propagation and absorption in the visible and near infrared range is possible and can find application in biomedical engineering using laser radiation.
No takes yet. Share an insight, caveat, or question.
S. S. Makarov (2014) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: