Answers are grounded in this paper and cite their sources.
Purpose: This study aimed to evaluate the marginal and internal fit of zirconia crowns fabricated using 3-dimensional (3D) printing technology with different offset parameters.Materials and Methods: A maxillary right first molar of a standard typodont (D85DP-500B.1; Nissin Dental, Kyoto, Japan) was prepared for a zirconia crown with a 1.0 mm margin. Virtual casts were obtained using an intraoral scanner (i700; MEDIT, Seoul, Republic of Korea). Crown designs were created with CAD software (Dentbird; IMAGOWORKS, Seoul, Republic of Korea) using specific parameters: cement space (50 µm), adaptive extra gap (0 µm), height for minimal gap (50 µm), and margin width (100 µm). Zirconia crowns were fabricated using a vat photopolymerization DLP 3D printer (TD6+; 3D Controls, Busan, Republic of Korea). Two offset groups were defined: the Offset -70 µm group (outermost XY-direction pixels reduced by one unit) and the Offset 0 µm group (no adjustment). All crowns were printed with a 50 µm Z-layer thickness. Eighteen crowns were fabricated (N = 9 per group). Marginal and internal fit measurements were conducted using the triple-scan method. The measured marginal and internal gaps were statistically compared using an independent t-test (α = 0.05).Results: The offset -70 µm group demonstrated significantly smaller marginal gaps (P<0.05) and internal gaps (P>0.05) compared to the offset 0 µm group.Conclusion: These findings suggest that adjusting the XY-direction offset may help minimize manufacturing errors, enhancing the overall accuracy of zirconia crown fabrication.
No takes yet. Share an insight, caveat, or question.
Son et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: