Answers are grounded in this paper and cite their sources.
In this contribution, based on the detailed understanding of the processes at the target during reactive high power impulse magnetron sputtering (HiPIMS), we demonstrate the deposition of both low- and high-index films and their implementation in optical interference filters with enhanced performance. We first investigate strategies for stabilizing the arc-free HiPIMS discharges above Si and Ta targets in the presence of oxygen. We show that hysteresis can be suppressed for these two target materials by suitable pulse-management strategies, ensuring good process stability without having to rely on any feedback control. Afterwards, we discuss the room temperature deposition of optically transparent SiO2 and Ta2O5 single layers as well as the fabrication of SiO2/Ta2O5 stacks such as 7 layer Bragg reflectors and 11 layer Fabry-Perot interference filters. We also analyze the optical and mechanical characteristics of these various coatings and compare them with their counterparts obtained by radio-frequency magnetron sputtering (RFMS). Among other findings, we observe that the coatings prepared by HiPIMS present higher refractive index and lower surface roughness values, suggesting a denser microstructure. In addition, the HiPIMS-deposited optical filters exhibit a better optical performance than their counterparts fabricated by RFMS, but it is especially with respect to the mechanical properties such as scratch resistance and low residual stress, that the coatings prepared by HiPIMS present the most dramatic improvements (up to 42% and 72% enhancement, respectively). Finally, we show that the stress values obtained for the HiPIMS-deposited SiO2 and Ta2O5 coatings are lower than for other deposition techniques commonly used in the fabrication of optical interference filters.
No takes yet. Share an insight, caveat, or question.
Hála et al. (2014) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: