Answers are grounded in this paper and cite their sources.
Molybdenum phosphide supported on activated carbon (MoP-AC) catalysts were successfully prepared from pyrolyzed heavy fuel oil (HFO) as a novel catalyst for hydrodeoxygenation (HDO) of palm oil to produce jet fuel oil. A facile preparation of activated carbon (AC) support was conducted via pyrolysis of HFO in temperatures range of 400 to 700°C and activation with designated ratios of KOH to C (0.5-2.0:1.0). Typical AC samples with a large surface area of 1527.4 m 2 /g were successfully synthesized using KOH to C ratio of 1:1 at 700°C. Then, MoP-AC catalysts were synthesized by wet impregnation with MoP loading of 5 – 20 wt%. SEM and TEM analyses revealed that MoP nanoparticles were uniformly dispersed on surface of MoP-AC with MoP loading of 5 wt%. An increase in MoP loading resulted in agglomeration of MoP nanoparticles. The key finding is that MoP-AC catalyst with 5 wt% loading exhibited 100% palm oil conversion with a liquid hydrocarbon yield of 54% at a temperature of 420°C. As desirable products, 90.4% jet fuel oil and 9.6% diesel oil was achieved. Furthermore, the short-term stability of MoP-AC catalysts with 24-hr on-stream operation was confirmed with the catalyst performance of 100% palm oil conversion and 89.2 % jet fuel oil selectivity. These results highlight a promising route for turning HFO, a byproduct of crude oil refining, into an alternative carbon-based catalyst support for producing renewable jet fuel.
No takes yet. Share an insight, caveat, or question.
Smuthkochorn et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: