Answers are grounded in this paper and cite their sources.
Objectives: The disinfection of fabricated prostheses is crucial to prevent cross-infection between dental laboratories and clinics. However, there is a lack of information about the effects of chemical disinfection on 3D-printed denture base resins. This study aimed to evaluate the impact of different disinfectants on the flexural strength, elastic modulus, micro-hardness, surface roughness (Ra), and change in color of 3D-printed and conventional heat-polymerized (HP) denture base resins (DBRs). Methods: A total of 240 specimens (80 bar-shaped (64 × 10 × 3.3 mm) and 160 disk-shaped (10 × 2 mm)) were made from HP and 3D-printed DBRs. For each resin, the specimens were divided into four groups (n = 10) according to the disinfectant solution. One remained in water without disinfection as a control group, while the other three groups were disinfected using 1% sodium hypochlorite, 2% glutaraldehyde, or 10% Micro 10+ for 30 min. The flexural strength, elastic modulus, micro-hardness, Ra, and color change were measured. The collected data were statistically analyzed using a two-way ANOVA and Tukey’s post hoc test (α = 0.05). Results: A significant decrease in flexural strength, elastic modulus, and hardness was found with sodium hypochlorite (p < 0.05). When comparing the resins per solution, the 3D-printed resin showed a significant decrease in flexural strength, elastic modulus, and hardness compared with PMMA (p < 0.001), while no change was found in the Ra of both resins with all disinfectants (p > 0.05). Disinfecting with sodium hypochlorite resulted in a significant increase in color change for both resins (p < 0.05); however, all the changes were within clinically acceptable limits. Sodium hypochlorite showed the highest color change, while 2% glutaraldehyde and 10% Micro 10+ showed no significant changes in the tested properties (p > 0.05). Conclusions: Neither resin showed a change in surface roughness with immersion in disinfectants. Sodium hypochlorite had an adverse effect on the flexural properties, hardness, and change in color of the PMMA and 3D-printed DBRs, while the other disinfectants had no effect on the tested properties.
No takes yet. Share an insight, caveat, or question.
Elhagali et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: