Answers are grounded in this paper and cite their sources.
Bi2Te3 based thermoelectric devices typically use a nickel layer as a diffusion barrier to block the diffusion of solder or copper atoms from the electrode into the thermoelectric material. Previous studies have shown degradation in the efficiency of these thermoelectric devices may be due to the diffusion of the barrier layer into the thermoelectric material. In this work, Ni, Co, Fe, and Mn are intentionally doped into Cu0.01Bi2Te2.7Se0.3 in order to understand their effects on the thermoelectric material. Thermoelectric transport properties including the Seebeck coefficient, thermal conductivity, electrical resistivity, carrier concentration, and carrier mobility of Cu0.01Bi2Te2.7Se0.3 doped with 2 atomic percent M (M = Ni, Co, Fe, Mn) as Cu0.01Bi2Te2.7Se0.3M0.02 are studied in a temperature range of 5-525 K. It is seen that the introduction of Ni, Co, Fe, or Mn does not affect the overall figure of merit, and therefore demonstrates that the diffusion barrier is not leading to device degradation as previously hypothesized. Any of these elements may be used as a diffusion barrier with Co being the best candidate based on both its electrical and mechanical properties.
No takes yet. Share an insight, caveat, or question.
Lukas et al. (2012) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: