Answers are grounded in this paper and cite their sources.
This study investigates the potential use of the organic fraction of oily sludge (OFOS) as a partial or complete substitute for the commercial petroleum-based processing oil PN-6Sh in rubber compounds based on synthetic isoprene rubber (SKI-3). OFOS was recovered from oily sludge by liquid extraction. The chemical characteristics of the original oily sludge, OFOS, and PN-6Sh were evaluated using gas chromatography–mass spectrometry (GC-MS), Fourier-transform infrared (FTIR) spectroscopy, and hydrocarbon group composition analysis. Hydrocarbon-group analysis showed closely matched light- and medium-aromatic fractions in OFOS and PN-6Sh, whereas GC-MS and FTIR were used as complementary qualitative characterization methods. Five formulations were investigated with a total processing-oil content of 6 phr and PN-6Sh replacement levels of 0–100%. Increasing OFOS content caused only a moderate change in Mooney viscosity, while the mechanical properties of the vulcanizates remained nearly unchanged throughout the replacement range. At 100% replacement, the elongation at break after thermal aging was 317%, identical to that of the control vulcanizate. Under the investigated laboratory conditions, complete replacement of PN-6Sh with OFOS preserved the evaluated mechanical properties and thermal-aging behavior without a practically meaningful loss in performance. Further application-specific qualification is required before industrial equivalence can be established.
No takes yet. Share an insight, caveat, or question.
Sagitova et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: