Answers are grounded in this paper and cite their sources.
Both surface and internal discontinuities, including porosity and roughness, are a common occurrence in laser powder bed fusion (L-PBF) additive manufacturing (AM) and can affect the fatigue performance of load-bearing structures. Hence, methods to assess surface-based discontinuities are essential, particularly on surfaces that are not often accessible in situ under mechanical load. Methods including X-ray computed tomography and ultrasonic inspection can be applied, however, they are limited by setup complexity and surface characteristics. This work utilises thermoelastic stress analysis (TSA) as an optical non-destructive evaluation (NDE) technique to identify and assess surface discontinuities in the lightweight L-PBF aluminium alloy, AlSi10Mg. This uses changes in surface stress measurements based on the thermoelastic temperature changes that arise from discontinuities when cyclically loaded. A bulk tensile specimen was compared to one with induced flat-bottom hole (FBH) inclusions to represent discontinuities. Five hole depths and five hole diameters were assessed. TSA scans were calibrated using strain gauge rosettes and compared to numerical models obtained using the finite element (FE) method. TSA could effectively identify and assess both the surface and non-surface sides of the specimens with the FBHs, and the stresses around them, which agreed with the FE models. All FBHs could be identified from the surface where they were made, while on the opposite side, FBHs that were up to 2.5 mm from the inspected surface could also be identified when the holes were 3.0 mm or more in diameter. TSA appears to be a viable NDE technique for the rapid assessment of stress raisers. This approach could be beneficial for the design and failure analysis of lightweight AM structures that include complex internal geometric features.
No takes yet. Share an insight, caveat, or question.
Rodrigues et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: