Answers are grounded in this paper and cite their sources.
This study evaluated the influence of two storage media on wear, sorption, surface roughness, flexural strength, and hardness of milled and 3D-printed provisional restorations after 72 h aging in distilled water and acidic solution at 37 °C. Two 3D-printed materials (ArmaTM, NextDentTM C&B MFH) and one milled PMMA block (AudentalTM) were evaluated for mechanical properties (wear resistance, Vickers microhardness) and physical performance, including sorption measured as mass (%) change. Surface characteristics were analysed using non-contact optical profilometry and scanning electron microscopy. The 3D printed restorations (ARMA & C&B) exhibited lower hardness and flexural strength, along with the high surface roughness and surface area loss, with ARMA reaching 0.86 ± 0.11 µm after water aging and 1.02 ± 0.15 µm after acidic aging. In contrast, milled materials showed lowest mass changes and superior overall stability proving its suitability for provisional restorations.
No takes yet. Share an insight, caveat, or question.
Aldhafyan et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: