Answers are grounded in this paper and cite their sources.
Thin-walled shells are fabricated via wire arc additive manufacturing (WAAM) combined with multi-pass spinning, and the microstructure and mechanical property evolution of the alloy under varying spinning reductions are systematically studied. The results show that spinning induces severe plastic deformation, leading to grain refinement, dislocation multiplication, and second-phase fragmentation. Due to differences in stress states, the inner and outer layers exhibit asynchronous evolution. In the early stage of spinning, a bimodal grain structure is formed. As the deformation increases, grains are continuously refined, and the bimodal structure gradually disappears. Mechanical tests show that hardness and strength initially increase and then slightly decrease with increasing deformation. When the spinning deformation reaches 65%, the difference in hardness decreases along the wall thickness direction. Meanwhile, the material achieves a favorable combination of strength and ductility, with an ultimate tensile strength (UTS) of 368.2 ± 18.4 MPa, yield strength (YS) of 340.0 ± 16.1 MPa, and elongation (EL) of 6.4 ± 1.2%. The hoop tensile properties show a consistent trend with axial tensile properties. When the reduction is small, fracture is dominated by crack initiation and propagation along the second-phase interfaces. When the spinning reduction is large, the fracture exhibits mixed-mode characteristics. This study elucidates the coordinated evolution mechanism of microstructure and strength, providing theoretical and process support for the preparation of high-performance rare-earth Mg alloy thin-walled components.
No takes yet. Share an insight, caveat, or question.
Chen et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: