Answers are grounded in this paper and cite their sources.
Helical milling can produce Ti-6Al-4V holes, but the combined effects of cutting conditions on wall surface roughness ( Ra ), within-hole variability, and burr height remain unclear. A replicated 24 full-factorial experiment examined tangential feed, axial helical pitch, fluid supply, and axial ultrasonic vibration across 48 holes. Roughness was quantified from 1536 readings in four axial zones; burr height was obtained from 12 circumferential measurements at the entrance of each hole. Factorial and mixed-effects analyses were supplemented by conservative paired-block inference for the fluid main effect and grouped validation of five regression models against a mean baseline. Within the fixed fluid–tool run structure, flood machining was associated with 12.94% lower hole-mean Ra (2.355 to 2.050 µm; p = 0.0285) and 25.10% lower mean within-zone Ra SD. Both associations had nominal paired-block support but did not survive FDR correction across six responses; fluid was confounded with tool identity and run position. Axial variability reductions were descriptive and unsupported by the conservative test, and no systematic top-to-bottom roughness gradient was detected. Ultrasonic vibration was unrelated to wall roughness but was associated with 26.3% higher burr height, whereas higher tangential feed was associated with 44.6% lower burr height. Burr height was the most predictable individual-hole response; hole-mean Ra showed moderate predictability, and axial Ra CV transferred poorly across replicates. Wide and incompletely calibrated Gaussian process intervals preclude individual-hole tolerance certification. The findings support multi-response assessment and response-specific validation of hole quality.
No takes yet. Share an insight, caveat, or question.
Ali et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: