Fault management in IP-over-WDM networks: WDM protection versus IP restoration

We consider an IP-over-WDM network in which network nodes employ optical crossconnects and IP routers. Nodes are connected by fibers to form a mesh topology. Any two IP routers in this network can be connected together by an all-optical wavelength-division multiplexing (WDM) channel, called a lightpath, and the collection of lightpaths that are set up form a virtual topology. In this paper, we concentrate on single fiber failures, since they are the predominant form of failures in optical networks. Since each lightpath is expected to operate at a rate of few gigabits per second, a fiber failure can cause a significant loss of bandwidth and revenue. Thus, the network designer must provide a fault-management technique that combats fiber failures. We consider two fault-management techniques in an IP-over-WDM network: (1) provide protection at the WDM layer (i.e., set up a backup lightpath for every primary lightpath) or (2) provide restoration at the IP layer (i.e., overprovision the network so that after a fiber failure, the network should still be able to carry all the traffic it was carrying before the fiber failure). We formulate these fault-management problems mathematically, develop heuristics to find efficient solutions in typical networks, and analyze their characteristics (e.g., maximum guaranteed network capacity in the event of a fiber failure and the recovery time) relative to each other.