Answers are grounded in this paper and cite their sources.
Oxygen functionalisation is widely used to enhance the surface polarity of carbon adsorbents and improve CO 2 affinity. However, excessive oxidation may reduce porosity and limit adsorption performance, and this requires investigation. Three-dimensionally ordered micro-mesoporous (3DOm) carbons have shown promising CO 2 capture, but the interplay between surface chemistry and pore architecture across different pressure regimes remains unclear. To address this, the present work systematically investigates the effect of controlled oxidation on hard-templated 3DOm carbons for CO 2 capture. Oxygen-functionalised carbons with oxygen contents of ∼5–18 at% were prepared using nitric acid, sulfuric acid, and their mixtures, with maximum oxidation at a nitric/sulfuric ratio of 1:3. Nitrogen adsorption analysis revealed that increasing oxidation reduced the BET surface area from 2215 to 1028 m 2 g −1 and the total pore volume from 3.70 to 0.89 cm 3 g −1 , hile preserving the graphitic framework and the characteristic three-dimensionally ordered micro-mesoporous architecture. Despite these changes, oxygen functionalisation enhanced low-pressure CO 2 uptake via additional electrostatic and weak hydrogen-bonding interactions with surface oxygen groups, complementing ultramicropore filling. As a result, the most strongly oxidised 3DOm achieved the highest CO 2 uptake (3.1–3.2 mmol g −1 at 100 kPa and 273 K) and CO 2 /N 2 selectivity (83.2 for a 15/85 vol% mixture at 298 K). At elevated pressures, uptake was dominated by surface area and mesopore volume, with the undoped 3DOm showing the highest capacity (16.2 mmol g −1 at 2 MPa and 273 K). All samples exhibited excellent regenerability under pressure-swing conditions, consistent with reversible physisorption. These findings demonstrate that controlled oxidation allows rational tuning of 3DOm carbons for either selective low-pressure CO 2 separation or high-capacity high-pressure capture, providing clear design guidelines for process-specific carbon capture applications.
No takes yet. Share an insight, caveat, or question.
Vorokhta et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: