Answers are grounded in this paper and cite their sources.
Zirconium (Zr) and its alloys are essential materials for nuclear reactor cladding due to their low neutron capture cross-section and good mechanical properties. Further improvement of their surface properties is needed to enhance corrosion resistance and mechanical durability. This study investigates the corrosion resistance and surface hardness enhancement of Zr surface by plasma electrolytic oxidation (PEO) with incorporation of chromium (Cr)-compound through the addition of potassium chromate (K 2 CrO 4 ) into the electrolyte. PEO treatments were conducted at a galvanostatic DC mode for varying processing times (3, 5, and 10 min), and the coatings were analyzed using a combination of microstructural, chemical, and electrochemical techniques. The results demonstrate that the addition of K 2 CrO 4 lowered the breakdown voltage and plasma discharge intensity, which facilitated the formation of coatings with reduced surface porosity and smaller pore sizes. Part of the current was consumed for the formation of chrome oxide (Cr 2 O 3 ). The Cr 2 O 3 phase was incorporated primarily in the outer layer within a predominantly Al 2 O 3 and ZrO 2 matrix, providing superior corrosion resistance of the coatings. The Cr-containing coatings exhibited corrosion current densities approximately 2.4–2.6 orders of magnitude lower than the Cr-free coating. The 5-min coating showed the lowest nominal mean corrosion current density and polarization resistance of (4.81 ± 0.84) × 10 −10 A/cm 2 and (1.15 ± 0.31) × 10 8 Ω cm 2 , respectively, although its value was not statistically different from those of the 3- and 10-min Cr-containing coatings. The mechanical hardness increased gradually with processing time and with increasing incorporation of Cr up to 2.73 at. %. The highest value was achieved at 753 ± 56 HV for 10 min treatment. This study confirms that the use of a chromate salt additive significantly improves the microstructural, mechanical, and anti-corrosion properties of PEO coatings on Zr substrates.
No takes yet. Share an insight, caveat, or question.
Sihotang et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: