Answers are grounded in this paper and cite their sources.
: The effects of scan speed on the densification, microstructural evolution, mechanical properties, and corrosion behavior of Zr–2.5Nb alloy fabricated by electron beam powder bed fusion (EB-PBF) were systematically investigated. The scan speed was varied from 6.0 to 4.5 m/s while the other major processing parameters were kept constant. Decreasing the scan speed from 6.0 to 5.0 m/s increased the relative density from 94.8% to above 99.8%, whereas a further decrease to 4.5 m/s provided no additional densification. Microstructural characterization revealed an hcp α-type Zr matrix containing a minor Nb-enriched bcc β-Zr phase distributed mainly along α-type boundaries. The indexed β-phase area fraction varied between 2.1% and 5.0%, accompanied by pronounced changes in the morphology and spatial distribution of the two phases with scan speed. Microhardness and compressive yield strength remained within relatively narrow ranges of 236–250 HV and 531–556 MPa, respectively, whereas the tensile response was more sensitive to processing conditions. The specimen fabricated at 5.0 m/s exhibited the most favorable strength–ductility combination, with an ultimate tensile strength of 683.5 ± 12.2 MPa, a yield strength of 617.4 ± 20.7 MPa, and an elongation of 21.9 ± 1.2%. In Hanks’ solution, the 5.5 m/s specimen exhibited the lowest corrosion current density and highest passivation potential, indicating the best corrosion resistance among the investigated conditions. These results show that the scan speed producing the optimum mechanical response does not necessarily provide the optimum corrosion performance, highlighting the need for property-specific process optimization of EB-PBF Zr–2.5Nb.
No takes yet. Share an insight, caveat, or question.
Li et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: