Answers are grounded in this paper and cite their sources.
This study describes the development of a multifunctional coating designed to enhance the antibacterial and photoprotective properties of 3D-printed Polylactic Acid (PLA). The strategy involves the synthesis of a β-cyclodextrin polymer (P-βCD) covalently functionalized with kojic acid (K) via a green aqueous-based process, followed by the supramolecular inclusion of xanthopterin (X) to yield the P-βCD-K-X complex. Structural confirmation was achieved through 1 H NMR, UV, and IR spectroscopy, while SEM analysis revealed a densely packed, particulate surface morphology. Broth microdilution assays demonstrated a stepwise functional enhancement, achieving a low minimum inhibitory concentration against Staphylococcus aureus (MIC = 0.18 mg/mL) and extending activity toward Gram-negative strains such as Klebsiella pneumoniae (MIC = 0.375 mg/mL) and Escherichia coli (MIC = 1.5 mg/mL). Surface-contact assays on coated PLA (5 mg/mL) revealed rapid antibacterial activity, achieving 88% bacterial inhibition within 5 min of contact and total bacterial suppression below the limit of detection (<100 CFU/mL) after 24 h. In vitro assays confirmed high cell viability (≥80%) in A549 cells across concentrations of 0.37–3.0 mg/mL. Optical characterization showed that coatings obtained from 5 to 10 mg/mL formulations lowered UV transmittance down to ≈1% near 350 nm and significantly boosted the Ultraviolet Protection Factor (UPF) of PLA from 9.2 (pristine PLA) up to 26.5 (10 mg/mL formulation), providing an “Very Good Protection” rating (BS EN 13758-1) by attenuating over 96% of harmful solar UV radiation. During accelerated weathering tests (96 h), while neat PLA photo-oxidized significantly (Carbonyl Index increased from 2.74 to 4.10), the functional coating prevented any net increase in surface oxidation (ΔCI = 0.00, maintaining a stable Carbonyl Index of 2.15). These quantitative findings highlight the potential of functionalized cyclodextrin polymers for engineering advanced, durable, and biocompatible antibacterial and photoprotective surface coatings.
No takes yet. Share an insight, caveat, or question.
Patamia et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: