Answers are grounded in this paper and cite their sources.
The non-circular cross-section hollow-part spinning is one of the recent breakthroughs of the traditional spinning processes. To reveal the mechanism of the non-circular spinning, the spinning process of the hollow-part with triangular cross-section was investigated. The spun part was divided into the straight-side and filleted-corner along the circumferential direction, and the bottom-corner, side-wall and opening-end along the generatrix direction. The simulation results show that during the non-circular part spinning, wrinkling occurs easily at the flange area of the straight-side; the distributions of equivalent stress and strain are 120° uniformly distributed along the circumferential direction. The differences on distributions of equivalent stress and strain between straight-side and filleted-corner are obvious. The maximum equivalent stress locates at the opening-end, where springback occurs easily. The maximum equivalent strain locates at the bottom-corner of straight-side and the centre of the side-wall of filleted-corner, where over-thinning of wall thickness occurs easily. The strain states of the straight-side and filleted-corner are different, the former is approximately in the state of plane strain and the latter is in the state of volumetric strain. A non-circular spinning device was designed and manufactured, a set of experiments were carried out. The experiment results conform well with the simulation one.
No takes yet. Share an insight, caveat, or question.
Cheng et al. (2013) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: