Genetic variation and prediction of additive and nonadditive genetic effects for six carcass traits in an Angus-Brahman multibreed herd.

Estimates of covariances and sire expected progeny differences of additive and nonadditive genetic effects for six carcass traits were obtained using records from 486 straightbred and crossbred steers from 121 sires born between 1989 and 1995 in the Angus-Brahman multibreed herd of the University of Florida. Steers were slaughtered at a similar carcass composition end point. Covariances were estimated by REML procedures, using a generalized expectation-maximization algorithm applied to multibreed populations. Straightbred and crossbred estimates of heritabilities and additive genetic correlations were within ranges found in the literature for steers slaughtered on an age- or weight-constant basis for hot carcass weight, longissimus muscle area, and shear force but equal to or less than the lower bound of these ranges for fat-related traits. Maximum values of interactibilities (i.e., ratios of nonadditive variances to phenotypic variances in the F1) and nonadditive genetic correlations were smaller than heritabilities and additive genetic correlations in straightbreds and crossbred groups. Sire additive and total direct genetic predictions for longissimus muscle area, marbling, and shear force tended to decrease with the fraction of Brahman alleles, whereas those for hot carcass weight and fat thickness over the longissimus were higher, and those for kidney fat were lower in straightbreds and F1 than in other crossbred groups. Nonadditive genetic predictions were similar across sire groups of all Angus and Brahman fractions. These results suggest that slaughtering steers on a similar carcass composition basis reduces variability of fat-related traits while retaining variability for non-fat-related traits comparable to slaughtering steers on a similar age or weight basis. Selection for carcass traits within desirable (narrow) ranges and slaughter of steers at similar compositional end point seems to be a good combination to help produce meat products of consistent quality.